Sunx SF1-N Series Instruction Manual

INSTRUCTION MANUAL
20mm Beam Pitch · General Purpose Area Sensor
Thank you very much for using SUNX products. Please read this
Instruction Manual carefully and thoroughly for the correct and optimum
use of this product. Kindly keep this manual in a convenient place for
quick reference.
WARNING
SF1-N Series
If this product is used as a sensing device for personnel
protection, serious body injury or death could result.
Never use this product as a sensing device with any press
machine, shearing machine, roll grinding machine, forming
machine, vulcanizer, or robot etc. for protection of a hand or a
part of the body.
This product does not include a self-checking circuit for safety
functions necessary to allow its use as a sefety device. Thus,
a system failure or malfunction can result in either an
energized or a de-energized output condition.
When this product is used as a sensing device in the
following applications and if a problem relating to 'law' or
'product liability' occurs, SUNX shall not be liable for the
failure and for the damage or less.
1) Use of this product installed to a machinery or a device as
a sensing device to detect a hand or a part of the
operator's body entering a dangerous area and stop the
machinery or the device.
2) Installation of this product to a protection device for
preventing to enter a dangerous area and use of this as a
sensing device which detectes a hand or a part of the
operator's body and open/close the door or window.
3) Use of this product as a sensing device for personnel
protection (including interlock).
For sensing devices to be used as safety devices for press
machines or for personnel protection, use products which
meet standards, such as OSHA, ANSI or IEC etc., for
personnel protection applicable in each region or country.
In case of using as a safety device for press machine, use a
product approved by the Ministry of Labor in Japan.