Universal Electronics Hashi User Manual page 12

Hashi User Manual
It is specified in bytes, determines whether packets will be fragmented. Packets exceeding the
2346 byte setting will be fragmented before transmission.
2. RTS Threshold:
This value should remain at its default setting of 2347. If inconsistent data flow is a problem,
only a minor modification should be made.
3. Beacon Interval:
Beacons are packets sent by an Access Point to synchronize a wireless network. Specify a value.
100 is default setting and is recommended.
4. Preamble Type:
The long preamble can reduce the guard interval packet therefore increasing the data capacity.
However, it's less reliable and may create higher data loss.
5. IAPP:
The default setting of Inter-Access Point Protocol is enabled.
6. Protection:
The default setting of BG protection is disabled.
7. Aggregation:
If it is enabled, the packets will be aggregated before they are forwarded. The default setting of
Aggregation is enabled.
8. Short GI:
Enabled it can reduce the guard interval time therefore increasing the data capacity. However,
it's less reliable and may create higher data loss.
9. WLAN Partition:
The default setting of WLAN partition is disabled.
10. STBC:
The default setting of Space Time Block Code is disabled.
11. 20/40MHz Coexist:
The default setting of 20/40MHz Coexist is disabled.
12. RF Output Power:
The default setting of RF Output Power is 100%.
Security
It is recommended to enable encryption on Hashi. Please establish connectivity before enabling
encryption.
11