Table of Contents
Advertisement
3. Safety
The measuring system M-Sens 2 designed and built according the latest technology has been tested to be safe
and was shipped in safe condition. Nevertheless persons or objects may be endangered by components of the
system if these are operated in an inexpert manner.
The operating instructions must therefore be read in its entirety, and the safety instructions must be adhered to.
If the device is used in a way that does not adhere to its intended and/or proper use, any liability or warranty on
the part of the manufacturer is void.
3.1 Regular use
Only original spare parts and accessories of ENVEA - SWR engineering must be used.
•
3.2 Identification of dangers
Possible dangers when using the measuring system are marked by the following symbols in the
•
operating instructions:
Warning!
This symbol in the operating instructions marks actions, which may represent a danger for life and limb
•
of persons when carried out in an inexpert manner.
Attention!
All actions which may endanger objects are marked with this symbol in the operating instructions.
•
3.3 Operational safety
The measuring system must be installed by trained and authorised personnel only.
•
Switch of the power supply for all maintenance, cleaning or inspection works on the tubes or on
•
components of the M-Sens 2. Follow the notes of the chapter maintenance.
Before hot-work the sensor must be removed from the installation place.
•
The components and electrical connections must be checked for damages regularly.
•
If a damage is found, it is to repaired before further operation of the instruments.
3.4
Technical progress
ENVEA - SWR engineering reserves the right to adapt technical data to the technical progress without
•
particular advance notice. If you have any questions, ENVEA - SWR engineering will be pleased to
inform you on possible changes and extensions of the operating instructions.
5
Advertisement
Table of Contents
