SWR Envea M-Sens 2 Operating Instructions Manual page 16

1.3. Alarm 2
1.3.1 Alarm type
1.3.2 Alarm value
1.3.3 Alarm dead time
1.3.4 Alarm hysteresis
1.3.5 Operation mode
1.4 Calibration
1.4.1 Calibration filter
1.4.2 Number of calibration points
When the multisensor function is switched on, up to 3 sensors can be declared!
1.4.3 Calibration factor for sensor 1
1.4.4 Calibration factor for sensor 2
1.4.5 Calibration factor for sensor 3
1.4.6 Calibration point 1
1.4.7 Raw value
1.4.8 Calibration point 2
1.4.9 Raw value
1.4.10 Calibration point N
1.4.11 Raw value
For 2.1 to 2.4 / 3.1 to 3.4 / 4.1 to 4.4 - same way
Choose: MIN / MAX
Range 0 ... 100 % in phys. units
Range 0.1 ... 99.9 s
Range 0.1 ... 99.9 %
Choose: Open or
closed current principle
Range 0.1 ... 999.9 s
Range 2 ... 5 base points
Rating of sensor signal with several
sensors used and disconnecting of
1 sensor with 0
Rating of sensor signal with several
sensors used and disconnecting of
1 sensor with 0
Rating of sensor signal with several
sensors used and disconnecting of
1 sensor with 0
Measurement range start and end
Record of input value
... (depends on the number of the
calibration points)
Measurement range init and end
Record of input value
16