SWR Envea M-Sens 2 Operating Instructions Manual page 19

1.4 CALIBRATION
Calibration filter
Number of calibration points
Calibration point 1 - measuring value
Calibration point 1 - calibration
The additional points are recorded just like the first one.
Calibration point 2 - measuring value
Calibration point 2 - calibration
Calibration point N - measuring value
Calibration point N - calibration
For 2.1 to 2.4 / 3.1 to 3.4 / 4.1 to 4.4 same as point 1
5 ANALOG OUTPUT
Start of range
End of range
Attenuation filter to smooth fluctuating signals during
calibration. (Has no effect on output.) 0.1 to 999.9 s
Input of number of necessary support points.
Measuring value to be displayed in physical units.
This is where the actual humidity value is entered as it
was determined in the lab based on a material sample.
Range: Start of the measuring range ... end of the measuring
range.
The sensor signal belonging to a measuring value is recorded
and the entered measuring value is allocated when the 
area is clicked. The value can also be entered numerically.
Measuring value to be displayed in physical units.
Range: Start of the measuring range ... end of the measuring
range.
Input value is recorded and allocated to the measuring value
to be displayed.
Measuring value to be displayed in physical units.
Range: Start of the measuring range ... end of the measuring
range.
Input value is recorded and allocated to the measuring value
to be displayed.
Value to be set for the current output minimum
(Standard 4 mA) Range 0 ... 22 mA
Value to be set for the current output maximum
(Standard 20 mA) Range 0 ... 22 mA
19