I/O Signals Transferred To/From Programmable Controller Cpu; I/O Signal List - Mitsubishi Melsec-Q Series User Manual

3
SPECIFICATIONS
3.3

I/O Signals Transferred to/from Programmable Controller CPU

This section describes the I/O signal assignment and signal functions.
3.3.1

I/O signal list

The following are the I/O signals of the Q68TD-G-H02 (H01).
The I/O numbers (X/Y) given in this chapter and later assume that the first I/O number of
the Q68TD-G-H02 (H01) is set to 0.
Input signal
(Signal direction:
Programmable controller CPU
Device No.
X0 Module ready
X1
X2
X3
X4
*
Reserved
X5
X6
X7
X8
X9 Operating condition setting completion flag
XA Offset/gain setting mode status flag
XB Channel change completion flag
Disconnection detection signal (Q68TD-G-H02 only)
XC Disconnection state monitor signal (Q68TD-G-H01
only)
XD Warning output signal
XE Conversion completion flag
XF Error flag
POINT
Table 3.8 I/O signal list
Q68TD-G-H02 (H01))
Signal name
The reserved signals marked * are used by the system and are unavailable for the
user. Should they be turned on/off in a sequence program, we cannot guarantee
the functions of the Q68TD-G-H02 (H01).
3.3 I/O Signals Transferred to/from Programmable Controller CPU
Output signal
(Signal direction:
Programmable controller CPU
Device No.
Y0
Y1
Y2
Y3
*
Y4
Reserved
Y5
Y6
Y7
Y8
Y9 Operating condition setting request
YA User range write request
YB Channel change request
YC
*
Reserved
YD
YE
YF Error clear request
3.3.1 I/O signal list
Q68TD-G-H02 (H01))
Signal name
3
- 21
1
2
3
4
5
6
7
8