12. Verification Checks
There are many details you can check.
Note:
All the checking instructions begin with the word 'CHECK'.
1.
To check the modes of all the channels -
Press keys: 'CHECK, ENTER'.
The display shows the modes of all the channels that are not turned off and
the present paradigm number.
2.
To check the mode and the parameters (DURATION, DELAY, INTERVAL
and M) of a specific channel (e.g. channel 2) -
Press keys: 'CHECK, 2, ENTER'.
You can check (and change) each parameter individually, as described in
'Setting Parameters' (Section 8).
3.
Checking the internal connections:
Example 1: To check which channels are internally connected to the output
of channel 4 -
Press keys: 'CHECK, 4, CONNECT, ENTER'.
If channel 4 does not have any output connections this instruction just clears
the display.
Example 2: To check which outputs are internally connected to the input of
channel 7 -
Press keys: 'CHECK, CONNECT, 7, ENTER'.
Example 3: To check all the internal connections -
Press keys: 'CHECK, CONNECT, CONNECT, ENTER'.
(or: 'CHECK, CONNECT, ENTER'.)
23