Operation - MULTIQUIP Whiteman Series Operation And Parts Manual

CAUTION
DO NOT attempt to operate the power
buggy until the Safety Information, General
Information, and Inspection sections of this
manual have been read and thoroughly
understood.
ELECTRIC START (WBH16E ONLY)
1. Before attempting to start the power buggy, make sure
that the safety kill switch (Figure 8) is not pushed
in. The power buggy will not start with the kill switch
engaged.
Figure 8. Kill Switch OFF
2. Place the travel control lever (Figure 9) in the
NEUTRAL position.
FORWARD
Figure 9. Travel Control Lever
PAGE 20 — WBH16/WBH16E POWER BUGGY (S/N 110401 & UP) • OPERATION AND PARTSMANUAL — REV. #1 (06/18/15)
KILL
SWITCH
(PULL)
NEUTRAL
REVERSE
3. Place the engine fuel lever to the ON position.
(Figure 10).
Figure 10. Engine Fuel Lever (ON Position)
4. Place the choke lever (Figure 11) in the CLOSED
position if starting a cold engine.
Figure 11. Engine Choke Lever (Closed)
NOTICE
The CLOSED position of the choke lever enriches
the fuel mixture for starting a cold engine. The OPEN
position provides the correct fuel mixture for normal
operation after starting, and for restarting a warm
engine.
5. Place the choke lever (Figure 12) in the OPEN position
if starting a warm engine or the temperature is warm.
Figure 12. Engine Choke Lever (Open)

OPERATION