Husqvarna P 524 Operator's Manual page 7

Headlights
The power switch for the headlights is found on the
steering wheel panel.
Forward and rearward pedals
The speed is gradually adjusted with 2 pedals. The left
pedal (1) is used to move forward, and the right pedal
(2) is used to move rearward. The product brakes when
the pedals are released.
PTO (Power take-off) button
The PTO button starts and stops the cutting deck. The
operator must sit to start the cutting deck.
Pull the PTO button out to engage the drive on the
cutting deck blades.
Push the PTO button in to disengage the drive on the
cutting deck blades.
To do a check of the safety circuit on page
See also
12 .
242 - 003 -
1
2
Lift lever for the cutting deck
The lift lever is used to lift and lower the cutting deck.
The product uses hydraulic pressure to lift the cutting
deck. To operate the lift lever, start the engine and push
down the PTO button.
When you move the lift lever to the transport position,
the cutting deck lifts and the blades stop in
approximately 5 seconds.
When you move the lift lever to the mow position, the
cutting deck lowers and the blades start to rotate.
Cutting deck
The cutting decks for this product are Combi cutting
decks with BioClip. BioClip cuts the grass into fertilizer.
The Combi cutting decks can also be used without
BioClip. Without BioClip the grass is ejected to the rear.
Symbols on the product
WARNING: Careless or incorrect use can
result in serious injury or death to the
operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Rotating blades. Keep body parts away from
the cover when the engine is on.
7