Table of Contents
Advertisement
• If for some reason your igniter fails to deliver a
spark, your heater can be started by inserting a lit
match through the pilot view hole while pushing
the control knob in while in the "PILOT" position.
Note: If pilot fails to remain lit, all valves should be
closed and waiting period of at least 5 minutes should
pass before attempting to light.
If you experience any ignition problem please consult
the "Troubleshooting" section of this manual.
Caution: Avoid inhaling fumes emitted from the
heater's first use. Smoke and odor from the burning of
oils used in manufacturing will appear. Both smoke and
odor will dissipate after approximately 30 minutes.
The heater should NOT produce thick black smoke.
Note: The burner may be noisy when initially turned
on. To eliminate excessive noise from the burner, turn
the control knob to the pilot position. Then, turn the
knob to the level of heat desired.
WHEN HEATER IS ON
Emitter screen will become bright red due to intense
heat. The color is more visible at night. Burner will display
tongues of blue and yellow flame. These flames should
not be yellow or produce thick black smoke, indicating
an obstruction of airflow through the burners. The flame
For a safe and pleasurable heating experience,
perform this check before each use.
BEFORE OPERATING
• I am familiar with entire owner's manual and
understand all precautions noted .
• All components are properly assembled, intact and
operable.
• No alterations have been made.
• All gas connections are secure and do not leak.
• Wind velocity is below 10 mph.
• Unit will operate at reduced efficiency below 40°F.
• Heater is outdoors (outside any enclosure).
• There is adequate fresh air ventilation.
• Heater is away from gasoline or other flammable
liquids or vapors.
• Heater is away from windows, air intake openings,
sprinklers and other water sources.
• Heater is at least 36w on top and at least 24 w on
sides from combustible materials.
should be blue with straight yellow tops. If excessive
yellow flame is detected, tum off heater and consult
the "Troubleshooting" section of this manual.
RE-LIGHTING
Note: For your safety, control knob cannot be turned
off without first depressing control knob in pilot position
and then rotating it to off.
• Turn control knob to off.
• Wait at least 5 minutes, to let gas dissipate, before
• Repeat the "Lighting" steps.
SHUTDOWN
• Turn the control knob clockwise to pilot (normally
Heater will be hot after use. Handle with extreme care.
• To extinguish pilot, depress control knob and
• Turn the cylinder valve clockwise to off and
Note: After use, some discoloration of the emitter
screen is normal.
Operation Checklist
• Heater is on a hard and level surface.
• There are no signs of spider or insect nests.
• All burner passages are clear.
• All air circulation passages are clear.
• Children, pets, clothing, flammable materials and
• Children and adults in the area have been alerted
• Children and adults in the area have been warned
AFTER OPERATION
• Gas control is in OFF position.
• Gas Tank valve is OFF.
• Disconnect Gas line.
• Heater is upright in a secure location.
-9-
attempting to relight pilot.
the burner will make a slight popping sound when
extinguished). Burner will extinguish but the pilot will
remain on.
WARNING
FOR YOUR SAFETY
continue to turn it clockwise to off.
disconnect the regulator when the heater is not in
use.
items that can be damaged from radiant heat are
away from the heater.
to the high temperature hazards: especially bums
and clothing fires.
not to touch heater near engine during operation
and until unit has cooled.
Advertisement
Table of Contents
