Table of Contents
Advertisement
COMPONENTS
• Remove all components from package.
ADDITIONAL REQUIREMENTS
The following items are not included, but are
necessary for the proper assembly of your heater,
DO NOT attempt to assemble without proper tools.
• Philips screwdriver w/medium blade.
• Adjustable opening wrench.
• Leak Detection Solution (Instructions on how to
make solution are included in step)
Note: You must follow a II steps to properly
assemble heater.
WARNING: California Proposition 65 Combustion
by products produced when using this product
contain chemicals known to the state of
California to cause cancer, birth defects, and
other reproductive harm.
If The Problem Is
Pilot Won't Light
Note: Heater operates at reduced
efficiency below 40°F (6°C)
Pilot Won't Stay Lit
Burner Won't Light
Burner Flame Is Low
Carbon Build-Up
Thick Black Smoke
Assembly Instructions
HARDWARE
Description
Large Bolt
Small Nuts
Small Bolt
Large Flat Washer
Cap Nut
Large Nuts
Small Screw
Wing Nut
Reflector Stud
Wrench
Troubleshooting
And This Condition Exists
Cylinder valve is closed
Blockage in orifice or pilot tube
Air in gas line
Low gas pressure with cylinder valve fully
open
Igniter fails
Dirt built up around pilot
Connection between gas valve and pilot
assembly is loose
Thermocouple is not operating correctly
Gas pressure is low
Blockage in orifice
Control knob is not in "ON" position
Gas pressure is low
Outdoor temperature is less than 40°F and
tank is less than 1/4 full
Supply hose is bent or kinked
Control knob fully on
Dirt or film on reflector and burner screen
Blockage in burner
-4-
Picture
Qty.
2
4
8
6
9
2
9
3
3
1
Then Do This
Open valve
Clean or replace orifice or pilot tube
Open gas line and bleed it (pressing
control knob in) for not more than 1 - 2
minutes or until you smell gas
Use match to light pilot; obtain new igniter
and replace
Clean dirt from around pilot
Tighten connection and perform leak
check
Replace the thermocouple
Turn cylinder valve OFF and replace
cylinder
Clear blockage
Turn control knob to on
Turn cylinder valve off and replace
cylinder
Use a full cylinder
Straighten hose
Check burner and orifices for blockage
Clean reflector and burner screen
Remove blockage and clean burner
inside and outside
Advertisement
Table of Contents
