Table of Contents
Advertisement
Turning the power on and off (standby
mode)
V CAUTION
Do not wear connected headphones when turning the
unit on or off (putting it in standby). Noise could damage
the headphone driver unit or harm your hearing.
CAUTION
i The unit enters standby mode if turned off when the unit
is operating on AC power supplied through a TASCAM
PS-P520E AC adapter (sold separately) or bus power
provided from a connected computer USB port.
i Turn down the volume of the monitoring system
connected to the unit before turning the unit on or off
(standby).
Turning the unit on
When the unit is off, press and hold the ¤ (HOME) [8]
button until the TASCAM DR-40X start-up screen appears.
The Home Screen appears after the unit starts up.
Start -Up screen
CAUTION
The first time a new unit is turned on after purchase, the
following settings must be made.
1) A menu to change the menu screen display language
will open.
Press the + or − button to move the cursor and select
(highlight) the language to be shown on the display.
Options:
English: use English
日本語 : use Japanese
Français: use French
Español: use Spanish
Deutsch: use German
Italiano: use Italian
Português: use Portuguese
Русский: use Russian
中文 : use Chinese
한글 : use Korean
After selection, press the ENTER/MARK button to
confirm.
Home screen
You can also change the display language setting with
the SYSTEM screen LANGUAGE item.(see "Setting the
language" on page 69)
2) A screen for setting the built-in clock will open.
Press the .or / button to move the cursor
(highlighted area), and use the + or − button to change
values.
After completing the setting, press the ENTER/MARK
button to confirm.
The start-up screen appears, followed by the Home
Screen after start-up completes.
Date/time setting may be skipped by pressing the
ENTER/MARK button. This setting can be made later.
(See "Setting the date and time" on page 18.)
Turning the unit off (standby)
Press and hold the ¤ (HOME) [8] button until LINEAR
PCM RECORDER appears on the display.
The unit turns off after it completes its shutdown process.
CAUTION
Always use the ¤ (HOME) [8] button to shutdown the
unit.
While the unit is on, do not remove the batteries,
disconnect the power cord when using a TASCAM
PS-P520E AC adapter (sold separately) or disconnect the
USB cable when using USB bus power. Doing so will cause
all recordings, settings and other data to be lost. Lost data
cannot be restored.
Resume function
The unit has resume function. When started up, the unit is
located to the position (time) where it left off when shut
down previously.
If the PLAY [7] button is pressed after start-up, the file the
unit was playing when shut down previously starts to be
played from the position (time) where the unit left off when
shut down.
NOTE
The required data are stored in the SD card. The resume
function does not work if the card is exchanged or
formatted.
3 – Preparation
17
TASCAM DR-40X
Advertisement
Table of Contents
