Emi Filter And Power Cord - GE PFSS9PKY Technical Service Manual

The heater can be checked directly as a separate
component by removing the freezer evaporator
cover (See
Freezer Evaporator Cover
harness can then be disconnected.
The duct heater has a resistance value of
approximately 3.18K Ω.
Duct Heater
Wire Harness
To remove the duct heater:
1. Remove the freezer evaporator cover (See
Freezer Evaporator Cover.
assembly on a protected surface so that the
inside faces upward.
2. Note the positioning of the wiring and untape
the wire harnesses.
3. Remove the 2 plastic wire ties (not shown) and
the duct heater wires from all retainers.
.) The heater wire
) and place the cover
Retainer
– 37 –
4. Press the top and bottom tabs inward and pull
the duct assembly from the ice room blower
housing.
Top View of Duct
Top Tab

EMI Filter and Power Cord

It is necessary to remove the EMI fi lter to replace the
power cord. The power cord is connected to the EMI
fi lter with a wire harness.
To remove the EMI fi lter and power cord:
1. Remove the machine compartment cover. (See
Machine Compartment Cover
2. Remove the Phillips-head screws that hold the
EMI fi lter bracket, water valve, power cord, and
ground wires to the cabinet.
3. Disconnect the EMI fi lter wire harness.
Disconnect
Bottom View of Duct
Bottom Tab
.)
(Continued next page)