GE PFSS9PKY Technical Service Manual page 54

3. Grasp the mullion and pull it vertically upward
to release it from the top and bottom retainers.
4. Pull out and disconnect the wire harness.
To disassemble the mullion assembly:
1. Remove the articulating door mullion assembly.
Caution: In the following step, care must be taken to
prevent breakage of the door closure cover and/or
door closure hinge.
2. Remove the door closure spring by pulling the
3. Lift the spring out of the door closure hinge.
Note: Be sure the spring sleeve is placed in the door
closure cover before installing spring.
Note: The door closure support is held to the door
closure cover with 13 tabs.
4. Using a putty knife or similar tool, carefully pry
Disconnect
– 54 –
(See
To remove the articulating door mullion
.)
assembly
top arm of the spring down and out of the door
closure cover.
Sleeve
Door Closure
Cover
and lift the door closure support from the door
closure cover.
Door Closure
Support
Spring
(Continued next page)