Structure Of The Operating Manual; Glossary - HDG Euro 30 Operation Manual

1.2 Structure of the operating manual

Chapter
1 Notes on this manual
2 Safety notes
3 Mode of operation
4 Planning and installation
5 Commissioning the system
6 Using the heating system
7 Cleaning and servicing the
heating system
8 Notes on dismantling and
disposal

1.3 Glossary

Term
Actuator
Central module
Flue gas fan
HDG Control
Lambda sensor
Reload signal
Safety temperature limiter
Sensor
Thermal safety device
1 Notes on this manual – Structure of the operating manual
The operating manual is structured as follows:
This explains ...
... how to use this operating manual.
... everything on the subject of safety that you should consider
when using the heating system.
... the structure and all of the features of the heating system.
... how to properly plan and install the heating system.
... how the heating system is put into initial service.
... how to properly operate the heating system.
... how to clean the heating system and who is responsible for its
maintenance.
... what has to be considered when dismantling and disposing of
the heating system.
Table 1/1 - Structure of the operating manual
Explanation
This is a component that carries out a certain function in the
heating system, for example the thermal safety device (TAS).
Pre-fabricated connection strip for electrical components
Creates a vacuum inside the boiler and provides the boiler with air
for combustion.
Boiler and heating system controller.
Electrical component which monitors residual oxygen levels in the
flue gas.
Electrical signal (in the form of an LED on the control unit) which
serves as a prompt to reload the fuel chamber.
An automatic device that interrupts and locks the supply of energy
and combustion air when the maximum permissible boiler
temperature is reached. The energy supply or combustion air
supply can only be re-enabled after the boiler temperature has
fallen below a preset limit and has been reset by hand or by means
of a tool.
Monitors certain parameters (e.g. temperature) and sends them to
the control system for analysis.
Safety device that allows cold water to flow through the safety
heat exchanger if the boiler becomes too hot.
Table 1/2 - Glossary
7