Cutting Wheels - DeWalt D24000 Instruction Manual

assembly. Keep brushes clean and sliding freely in their
guides. Always insert a replacement brush in the same
orientation in the holder as the used brush was prior to its
removal. Carbon brushes have varying symbols stamped
into their sides, and if the brush is worn down to the line
closest to the spring, brushes must be replaced. Use only
identical D WALT brushes. Use of the correct grade of brush
e
is essential for proper operation. New brush assemblies are
available at D WALT service centers. The tool should be
e
allowed to "run in" (run at no load) for 10 minutes before
use to seat new brushes.
Fig. R
Transportation and Storage (Fig. S)
The rear water attachment
7
attachment 9 and water pan
to make carrying easier (Fig. S).
Fig. S
TOP
11
Lubrication

WARNING: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This can
seriously affect the life and performance of the tool
and may result in personal injury.
D WALT tools are properly lubricated at the factory and are
e
ready for use. However, it is recommended that, once a year,
you take or send the tool to a certified service center for a
thorough cleaning and inspection.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this.
41
, cutting cart water
11 may be nested together
7
9

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
1. Insert the water pump into a bucket of clean water and
pump the water through the hose system.
2. Turn off and unplug the saw from the power supply.
3. Place a 5 gallon (19 l) bucket under the drain plug.
Remove the drain plug and allow the water to empty
into the bucket.
4. Slide the cutting cart off the rail system. Spray the
cutting cart with a hose or wipe with a grout sponge
or rag.
5. Wipe the rails, motor housing, and support arm with a
grout sponge or a rag. Spray lubricants are not required
on the guide rail or wheels.
6. Clean the water pan by spraying with a hose or wiping
with a grout sponge.
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Stand D24001 (Fig. T)

Cutting wheels

7" (180 mm) Ceramic
10" (254 mm) Ceramic
10" (254 mm) Porcelain
Fig. T
D24001
ENGlIsH
WALT
e
DW4760
DW4761
DW4762
41