Specifications - Makita HS7601 Instruction Manual

ENGLISH (Original instructions)
1-1. Lever
2-1. Clamping screw
3-1. Clamping screw
4-1. Cutting line (0 ﾟ position)
4-2. Cutting line (45 ﾟ position)
5-1. Switch trigger
5-2. Lock-off button
6-1. Hex wrench
6-2. Shaft lock
6-3. Loosen
6-4. Tighten
7-1. Inner flange
7-2. Saw blade
7-3. Outer flange
7-4. Hex bolt

SPECIFICATIONS

Max. cutting depth
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
8-1. Mounting shaft
8-2. Inner flange
8-3. Saw blade
8-4. Outer flange
8-5. Hex bolt
9-1. Mounting shaft
9-2. Inner flange
9-3. Saw blade
9-4. Outer flange
9-5. Hex bolt
10-1. Mounting shaft
10-2. Inner flange
10-3. Saw blade
10-4. Outer flange
10-5. Hex bolt
Model
Blade diameter
at 0°
at 45°
No load speed
Overall length
Net weight
Safety class
noise level determined
) : 87 dB (A)
pA
) : 98 dB (A)
WA
ENE078-2
Vibration
The vibration
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-2
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
4
10-6. Ring
11-1. Hex wrench
12-1. Dust nozzle
12-2. Screw
13-1. Vacuum cleaner
13-2. Hose
15-1. Clamping screw
15-2. Rip fence
16-1. Screw
17-1. Screw
18-1. Triangular rule
19-1. Limit mark
20-1. Screwdriver
20-2. Brush holder cap
HS7601
190 mm
66 mm
46 mm
-1
5,200 min
309 mm
4.0 kg
/II
total value (tri-axial
2
) : 2.5 m/s
h,W
2
ENG900-1
vector sum)
or less
ENG901-1