Starting Quick Test Mode - Maytag MHWC7500YW0 Manual

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY

Starting Quick Test Mode

All of the steps below must be done in sequence in order to reach the Diagnostic Test. This exceutes the automatic test but does not run the
user interface test.
1. Close the door.
2. Rotate the cycle control knob and select the CLEAN WASHER cycle (see illustrations below).
Whirlpool cycle control knob
NOTES:
Please ensure that current washer status is in PROGRAM (SELECTION) mode. Otherwise, please follow the instructions below to bring it
back to PROGRAM (SELECTION) mode.
PAUSE mode: Press and hold CANCEL/DRAIN button for 3 seconds for reset, then turn cycle control knob to enter PROGRAM mode.
FAILURE mode: Turn cycle control knob to enter PROGRAM mode.
EXECUTION mode: Press and hold CANCEL/DRAIN button for 3 seconds for reset, then turn cycle control knob to enter PROGRAM mode.
STANDBY mode: Press START button or turn cycle control knob to enter PROGRAM mode.
DELAY START mode: Turn cycle control knob to enter PROGRAM mode.
3. Press the START button 4 times within 5 seconds (see illustrations below).
Whirlpool model
4. The following steps are automatically driven, or they can be manually advanced by pressing the Cancel/Drain button twice. See the
Quick Diagnostics Test chart on page 8.
NOTES:
I To cancel out of this mode, rotate the cycle control knob (this exits the program).
I Press CANCEL/DRAIN twice to advance to the next step of the procedure.
I If the starting procedure fails, turn the cycle control knob back to the CLEAN WASHER cycle, then repeat the starting procedure.
Maytag cycle control knob
PAGE 7
Maytag model