Description Of Electronic Panel - Culligan Aqua-Cleer MFP 4-44-MD 400 User's & Technical Manual

Photo No. 7: "Pressure Pump Adj." label
INSTALLATION
THE EQUIPMENT MUST ONLY BE INSTALLED
BY AUTHORIZED
CENTER TECHNICIANS.
ATTENTION
THE AQUA-CLEER MFP 4-44 MD SHOULD NOT
BE PLACED
EQUIPMENT; HOWEVER, IF IT HAS TO BE
USED NEAR OR ON OTHER EQUIPMENT, THE
AQUA-CLEER
WATCHED OVER TO CONTROL ITS NORMAL
OPERATION IN THE CONFIGURATION USED.
FOR ALL PREINSTALLATION AND PLUMBING
AND
INSTRUCTIONS, REFER TO THE RELEVANT
SECTION IN THE SERVICE PART.
DESCRIPTION OF
KEYBOARD
(unless otherwise specified, see fig. 3)
Figure 3:
The following keys are at the operator's disposal:
- MAIN SWITCH (Item 13 of Figure 3)
Turn to position (O) to disconnect the equipment power supply. Turn
to position (I) to enable the power supply.
EQUIPMENT ON STANDBY
Press to start the equipment operation cycle. Press this key again to
stop it.
6
CULLIGAN SERVICE
NEAR OR ON
MFP 4-44 MD MUST
ELECTRICAL INSTALLATION
ELECTRONIC PANEL
Aqua-Cleer MFP 4-44 - MD – User
RESETTING ALARMS (Reset)
In alarm status, whatever the cause, press this key to silence the
beep. The alarm message remains on the display.
ATTENTION
-DISPLAY
The MFP 4-44 MD has a multifunction display able to provide the user
with all useful information on machine operation in real-time.
ATTENTION
OPERATION
PRODUCTION
(unless otherwise specified, see fig. 3)
When the main switch located on the side of the electronic panel is in
OTHER
position "1", the display shows:
BE
Press
The display now shows
after about 15 seconds the pump starts, then if the feed pressure
remains above the minimum setting level the equipment will continue
regular operation.
The display then shows on page 1
value indicating product water conductivity.
By pressing the key
pages in sequence:
on page 2
value indicating feed water conductivity;
on page 3
value indicating salt removal percentage;
on page 4
value indicating user product water flow rate in l/h;
on page 5
value indicating drain water flow rate in l/h;
on page 6
value indicating recovery ratio percentage;
To go back to page 1 from page 6, press in sequence
SANITIZATION
KEY FOR FUNCTIONS TO BE CARRIED OUT
EXCLUSIVELY BY
CENTER TECHNICIANS.
UP and DOWN
KEYS FOR FUNCTIONS TO BE CARRIED OUT
EXCLUSIVELY BY
CENTER TECHNICIANS.
FOR USER
Standby mode
to start the cycle.
OPERATE Mode initializing
OPERATE mode Prod. Cd. -----
it is also possible to display the following
OPERATE mode FeedCd----S
OPERATE mode SaltRej
OPERATE mode Product ---- l/h
OPERATE mode Reject ---- l/h
OPERATE mode RecRatio.----%
M006-06 – Rev. 01 – 05/2012
AUTHORIZED SERVICE
AUTHORIZED SERVICE
(SERVICE) WATER

S
. ----%
.