Belkin OMNIGUARD F6C110-RKM-2U User Manual page 3

WARNING
NOTICE: This equipment has been tested and found to
comply with the limits for a Class B computing device in
accordance with the specifications in Subpart J of Part 15 of
FCC Rules and the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference of the
Canadian Department of Communications. These limits are
designed to provide reasonable protection against such
interference in a residential installation. This equipment
generates and uses radio frequency and if not installed and
used properly, that is, in strict accordance with the
manufacturer's instructions, this equipment may cause
interference to radio and television reception. If this equipment
does cause interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient the receiving antenna.
• Relocate the computer with respect to the receiver.
• Move the computer away from the receiver.
• Plug the computer into a different outlet so that the
computer and receiver are on different branch circuits.
• Shielded communications interface cables must be used with
this product.
WARNING! Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
WARNING! RISK OF ELECTRICAL SHOCK. HAZARDOUS LIVE PARTS
INSIDE THIS POWER SUPPLY ARE ENERGIZED FROM THE BATTERY
EVEN WHEN THE AC INPUT POWER IS DISCONNECTED.
TO DE-ENERGIZE THE OUTPUTS OF THE UPS:
1. IF THE UPS IS ON, PRESS THE ON/OFF BUTTON FOR 1
SECOND.
2. DISCONNECT THE UPS FROM THE AC POWER OUTLET.
3. TO DE-ENERGIZE THE UPS COMPLETELY, DISCONNECT THE
BATTERY.
4
WARNING
CAUTION! TO REDUCE THE RISK OF ELECTRICAL SHOCK IN
CONDITIONS WHERE LOAD EQUIPMENT GROUNDING CANNOT BE
VERIFIED, DISCONNECT THE UPS FROM THE AC POWER OUTLET
BEFORE INSTALLING A COMPUTER INTERFACE CABLE. RECONNECT
THE POWER CORD ONLY AFTER ALL SIGNALING CONNECTIONS
ARE MADE.
CAUTION! CONNECT THE UPS TO A TWO-POLE, THREE-WIRE,
GROUNDING AC POWER OUTLET. THE RECEPTACLE MUST BE
CONNECTED TO APPROPRIATE BRANCH PROTECTION (CIRCUIT
BREAKER OR FUSE). CONNECTION TO ANY OTHER TYPE OF
RECEPTACLE MAY RESULT IN A SHOCK HAZARD AND VIOLATE
LOCAL ELECTRICAL CODES.
5