Belkin OMNIGUARD F6C110-RKM-2U User Manual page 7

Rackmount ups
Hide thumbs Also See for OMNIGUARD F6C110-RKM-2U:
Table of Contents

Advertisement

PRODUCT INSTALLATION
Mounting the UPS within the Rack
The OmniGuard Rackmount UPS includes a mounting kit, which includes two
mounting brackets for a standard 19-inch (48.3cm) rack and eight retaining
screws for mounting the brackets to the UPS device. Note that the screws and
nats necessary for mounting the UP actual rack are
Other configurations are also available as options including: mounting brackets
for a 23-inch (58.4cm) standard rack, vertical mounting, or wall mounting.
Attaching the Brackets to the UPS
To prepare the UPS for mounting, you need to attach the mounting brackets first
to the UPS device. The mounting bracket screw holes are located on the side
panels of the UPS, toward the front of the UPS. Align the mounting bracket with
the mounting bracket screw holes and then attach the mounting bracket using
four retaining screws for each bracket.
Diagram 1: Mounting the UPS into the Rack
Attaching the Brackets to the Rack
Locate the appropriate rackmount screws associated with your rack. Align the
mounting bracket with the mounting bracket screw holes and then attach the
mounting bracket using the appropriate rack screws.
12
included.included111111
PRODUCT INSTALLATION
CAUTION! Use two or more people when installing the UPS into
the rack. Use caution, the UPS is extremely heavy. Do not move
the rack after the units have been installed. The rack may be
unstable due to the weight distribution. Now the UPS is ready
for the normal start-up procedure.
Connecting to an AC Power Source
Once physically installed, plug the UPS into a two-pole, three-wire, grounded
receptacle only. Do not use extension cords or adapter plugs as these devices
create additional issues with the electrical flow and will void the Belkin power
warranty associated with the UPS.
Important: After plugging in the UPS, check the Site Wiring Fault (SWF) LED on
the front panel of the unit. If the LED is illuminated, then the UPS is plugged
into an improperly wired AC outlet.
CAUTION! If the UPS indicates a site-wiring fault, have a
qualified electrician correct the problem.
Charging the Battery
The OmniGuard Rackmount UPS will charge the internal batteries whenever the
unit is connected to an AC power source and the circuit breaker on the back
panel is in the "On" position. It is recommended that the batteries be charged
for a minimum of four hours before use. If the UPS is used immediately, battery
run time may be less than normally expected.
13

Advertisement

Table of Contents
loading

Table of Contents