Table of Contents
Advertisement
When connecting the TP cables to the PVS 305SA, take care not to cross-connect
the cables; connect input cable 1A to the RJ-45 port labeled 1A, and input cable 1B
to the RJ-45 port labeled 1B. Likewise, connect input cables 2A, 3A, or 4A to its
corresponding numbered A port, and cable B to its B port (see figure 2-7).
PVT RGB D
Input #1
Cable from
PVT Output A
Cable from
PVT Output B
RGB A
RGB B
OUT
OUT
Rear Panel
Figure 2-7 — Connect RGB wallplate output cables to the switcher RGB
inputs.
b
Composite video and audio inputs ("Video") — Each composite video input
needs one TP cable. Using TP cable, connect up to two composite video and
audio sources via PVT wallplates to these two RJ-45 female
connectors labeled 3 and 4; each one is for video and audio
combined.
These ports can also be configured via RS-232 for RGB
N
video input. Default is for composite video.
When connecting the TP cables to the switcher, take care to
connect input 3's cable to the RJ-45 port labeled 3, and input 4's cable to the
RJ-45 port labeled 4 (see figure 2-8).
Though these ports can also be used for RGB signals, do not connect an RGB
cable (cable A) to the top ports when connecting composite video inputs to the
lower ports.
See the note on page 2-6 about cables and cable termination.
PVT CV D
Input #3
Rear Panel
Rear Panel of PVS 305SA
Figure 2-8 — Connect the composite video wallplate output cables to
the switcher video inputs.
N15779
RGB
1A
2A
I
N
POWER
P
U
T
S
1B
2B
12V
5A MAX
RGB Input Connectors on
Rear Panel of PVS 305SA
3A RGB
4A RGB
RGB
RGB
3B
4B
VIDEO
VIDEO
Composite Video Input
Connectors on
PVS 305SA Switcher • Installation
PVT RGB D
Input #2
Cable from
PVT Output A
Cable from
PVT Output B
RGB A
RGB B
OUT
OUT
Rear Panel
3A RGB
4A RGB
RGB
RGB
3B
4B
VIDEO
VIDEO
PVT CV D
Input #4
Composite Video
Cable from
PVT Output
Rear Panel
2-7
Advertisement
Table of Contents
