Troubleshooting - Belkin F6C1000-EUR, F6C700-EUR, F6C1400-EUR User Manual

P73335u_UPS_man.qxd

7. Troubleshooting

PROBLEM
UPS is not turned on.
(No alarm, no LED lights.)
UPS does not provide
expected back-up time.
4/30/01 12:19 PM Page 19
POSSIBLE CAUSE
ON/TEST button is not
pushed.
The rear panel circuit
breaker is tripped. (Button
is out.)
UPS fault
Batteries inside the UPS
are not fully charged.
UPS is overloaded.
Batteries are weak.
Batteries are weak.
19
SOLUTION
Press the ON/TEST
button to turn on the
UPS. (Refer to section 4
to turn on the UPS.)
1. Reduce some loads
connected to the UPS
2. Reset the circuit
breaker. (Push
button in.)
Call for qualified service
personnel if above
actions do not solve the
problem.
Recharge the batteries
for at least four hours.
Remove some
unnecessary loads.
Batteries wear faster
when used often or
operating at higher
temperature.
If the battery is near
the end of its life,
replace the battery
even if the REPLACE
BATTERY LED does not
light. (Refer to section 6
for replacing batteries.)
Call for service.
En