Summary of Contents for Voxx Electronics PRESTIGE PE1BTWZ
Page 1
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. 2018 Voxx Electronics Corporation. All rights reserved.
Table of Contents Using Your Remote Control ..............3 Arming the Security System .............. 3 Disarming the Security System ............3 Two Stage Door Unlock (optional) ............. 3 Bypassing the Shock Sensor ............3 Alarm City Mode ................4 User Selectable Notification Chirps ........... 4 User Selectable LED .................
To Arm the Alarm the bypass both detection stages press the button 3 times within 5 seconds. *Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more than 3 seconds. 2018 Voxx Electronics Corporation. All rights reserved.
City Mode City Mode allows the user to change the sound of the alarm system to make it easily identified when the alarm is trigger. To enter City Mode press the button 4 times within 10 seconds. User Selectable Notification Chirps System ARM/DISARM chirps can be toggled ON or OFF without entering the programming feature banks.
Within 10 seconds, press and release the Brake pedal 3 times. The alarm system will stop sounding and enter the (by-passed) mode. You can now start and operate the vehicle normally. This feature must be programmed ON by an autorized dealer. 2018 Voxx Electronics Corporation. All rights reserved.
Page 6
Custom Code Valet Override (Optional) Unlike the default Valet Override, Custom Code Override is a user personalized code that offers a higher lever of security. If the user chooses to use Custom Code Override, Feature Bank 2 ; Feature 9 must be programmed for “Custom Code”. Once the option has been selected the code must be programmed.
The engine is over-revved (tach checking only). Valet Mode is active. Refer to the Valet Mode section of this manual on page 5. Remote Start Ready Mode is not set. Manual transmission vehicle’s only. 2018 Voxx Electronics Corporation. All rights reserved.
Remote Start Ready Mode must be enabled if your vehicle is equipped with a manual transmission. Remote Start Ready Mode - Manual Transmission Vehicles Only To activate the remote start function, the system must first be in Remote Start Ready Mode.
Remove the keys from the ignition and exit the vehicle. Press the button to lock the vehicle’s doors if desired. Note: Do not leave children or animals unattended in the vehicle when using the quick-stop feature. 2018 Voxx Electronics Corporation. All rights reserved.
Turbo Timer (Optional) This option will keep the engine running to allow the vehicle’s turbo to properly cool down before shutting the engine off. To engage the Turbo Timer feature: With the vehicle running via the ignition key and your foot off of the brake pedal.
Remote Shutdown 3 Flashes Brake ON 4 Flashes Manual Tramission Ready Mode 5 Flashes Hood Open 6 Flashes Low Tach Signal 7 Flashes Tach / Crank Average not learned 8 Flashes High Tach Signal 2018 Voxx Electronics Corporation. All rights reserved.
Page 12
2 Way Remote Control Notifications FUNCTION BEEPS / LED FLASHES Lock 1 Beep / Flash Unlock 2 Beeps / Flashes Remote Start Activation RS Activation Melody Confirm Remote Start 4 Beeps / Flashes Remote Start Running 1 Flash per 5 seconds for duration run time Remote Start Shutdown RS Shutdown Melody Alarm Trigger Event...
2. Remove the old battery, observing the +/- symbols on the batteries and replace with a new battery. 3. Reassemble the halves of the remote control 4. Test operation of the remote control. 2018 Voxx Electronics Corporation. All rights reserved.
LIMITED LIFETIME WARRANTY Applies to Prestige Series Control Modules, Sirens, Sensors, and Relays. Voxx Electronics Corporation (the Company) warrants to the original purchaser of this product that should this product or any part thereof, (other than transmitters) under nor- mal use and conditions, be proven defective in material or workmanship during the life-...
Page 15
2. This device must accept any interference received, including any interference that may cause undesired operation. Warning! Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. PATENTED: www.voxxintl.com/company/patents 2018 Voxx Electronics Corporation. All rights reserved.