Troubleshooting - Euro-Pro Shark SC620F Owner's Manual

Professional garment steamer 120v., 60 hz, 1500 watts
Table of Contents

Advertisement

CONSIGNES DE SÉCURITÉ SUPPLÉMENTAIRES (suite)
1. Afin d'éviter une surcharge électrique, n'utilisez pas un autre appareil sur le
même circuit électrique.
2. Si vous devez absolument utiliser une rallonge, utilisez un cordon 14 de 15
ampères. Les rallonges de calibre moindre pourraient surchauffer. Disposez les
rallonges de façon à ce que personne ne puisse les tirer ou y trébucher.
3. Ne laissez pas l'appareil sans surveillance lorsqu'il est branché.
CONSERVEZ CES INSTRUCTIONS
POUR USAGE DOMESTIQUE SEULEMENT
AVERTISSEMENT:
Afin de réduire les risques de choc
électrique, cet appareil est doté d'un cordon à fiche polarisée (une
lame est plus large que l'autre). Cette fiche ne s'insère que dans
un seul sens dans une prise polarisée. Si la fiche ne s'insère pas
dans la prise, retournez la fiche. Si elle ne s'adapte toujours pas,
contactez un électricien qualifié afin d'installer la prise appropriée.
N'altérez la fiche d'aucune façon.
MISE EN GARDE:
Le boyau peut devenir chaud à l'usage.
Ne tenez, tirez ou déplacez JAMAIS l'appareil en fonction par le
boyau. Si vous devez déplacer le presseur à vapeur, utilisez la tige
à vêtement. Tenez la tête du presseur par la poignée, jamais par le
boyau.
12
IMPORTANT NOTES DURING OPERATION
If steam hose gurgles during use:
This is a normal result of
condensation collecting inside the
hose. Simply lift the steam
diffuser/handgrip upward until the
hose is extended to its full height.
The gurgling will disappear when
the excess moisture inside the
hose has had a chance to drain
back into the base.
TROUBLE SHOOTING
Below is a chart detailing the most common problems, their causes and solutions.
PROBLEM
CAUSE
1.
Steamer is not
plugged into
electrical outlet.
Steamer Does
2.
The water tank is
Not Get Hot
empty and the
reservoir has
drained.
1.
Water level is too
No Steam
low.
Water Drips
1.
Condensation has
From The
formed inside the
Steam Diffuser
steamer hose.
If the steamer stops producing
steam then starts again:
You may wish to examine the
inside of the reservoir. The most
common reason for this effect is
the accumulation of sediment from
mineral laden water.
Clean the sediment from inside the
water reservoir following the
instructions on page 8.
SOLUTION
1.
Plug power cord into
electrical outlet.
2.
Refill water tank
following instructions on
page 7.
1.
Refill the water tank
following instructions on
page 7.
1.
Hold the steamer hose
upright fully extended
and allow excess
moisture to drain back
in the water reservoir.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shark sc620s

Table of Contents