AEG FSK31600Z User Manual page 9

German de- French degrees
grees (°dH)
<4
1) Factory setting.
2) Do not use salt at this level.
Regardless of the type of detergent
used, set the proper water hardness
level to keep the salt refill indicator
active.
Multi-tabs containing salt
are not effective enough to
soften hard water.
How to set the water softener
level
Make sure the appliance is in user mode.
1. Wait until the indicators
and
the indicator
indicator
intermittent flashing of the indicator
shows the current setting.
• e.g. 5 flashes + pause + 5 flashes
= level 5.
2. Press the programme button
repeatedly to change the setting.
Each pressing of the programme
button increases the level number.
After reaching level 10, the count
starts again from level 1.
3. Press on/off to confirm the setting.
6.3 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
mmol/l
(°fH)
<7
are off and
flashes. The
still flashes. The
Clarke de-
grees
<0.7 < 5
How to activate the acoustic
signal for the end of
programme
Make sure the appliance is in user mode.
1. Press the programme button
immediately.
• The indicator
on.
• The indicator
flashes.
2. Wait until the indicator
are off. The indicator
• The
current setting:
= Acoustic signal off.
3. Press the programme button to
change the setting.
• indicator on = Acoustic signal
on.
4. Press on/off confirm the setting.
6.4 AirDry
AirDry improves the drying results with
less energy consumption.
ENGLISH
Water softener lev-
el
2)
1
and
and
still flashes.
indicator shows the
indicator off
9
are