Cisco MDS 9000 Series Configuration Manual page 241

Configuring FC-SP and DHCHAP
MDS-9216# show fcsp interface fc 1/6
fc1/6
Step 8
Repeat these steps on the connecting MDS 9509 Switch.
MDS-9509# show wwn switch
Switch WWN is 20:00:00:05:30:00:38:5e
MDS-9509(config)# feature fcsp
MDS-9509(config)# fcsp dhchap password rtp9509
MDS-9509(config)# fcsp dhchap devicename 20:00:00:05:30:00:54:de password rtp9216
MDS-9509(config)# interface fc 4/5
MDS-9509(config-if)# fcsp on
MDS-9509# show fcsp dhchap database
DHCHAP Local Password:
Other Devices' Passwords:
MDS-9509# show fcsp interface fc 4/5
Fc4/5
You have now enabled and configured DHCHAP authentication for the sample setup in
DHCHAP Authentication, on page
Default Settings
The following table lists the default settings for all fabric security features in any switch.
Table 18: Default Fabric Security Settings
Parameters
DHCHAP feature
DHCHAP hash algorithm
DHCHAP authentication mode
DHCHAP group default priority exchange order
DHCHAP timeout value
fcsp authentication mode:SEC_MODE_ON
Status:Successfully authenticated
Non-device specific password:*******
Password for device with WWN:20:00:00:05:30:00:54:de is *******
fcsp authentication mode:SEC_MODE_ON
Status:Successfully authenticated
222.
Default
Disabled
A priority list of MD5 followed by SHA-1 for DHCHAP
authentication
Auto-passive
0, 4, 1, 2, and 3 respectively
30 seconds
Cisco MDS 9000 Series Security Configuration Guide, Release 8.x
Default Settings
Figure 19: Sample
223