Cisco MDS 9000 Series Configuration Manual page 103

Configuring Security Features on an External AAA Server
+radius-server host testhost1 authentication accounting
+radius-server host testhost2 authentication accounting
To display the TACACS+ global and/or server configuration stored in the temporary buffer, use the show
tacacs+ pending command.
switch(config)# show tacacs+ pending-diff
+tacacs-server host testhost3
+tacacs-server host testhost4
Committing the RADIUS Distribution
The RADIUS or TACACS+ global and/or server configuration stored in the temporary buffer can be applied
to the running configuration across all switches in the fabric (including the originating switch).
To commit RADIUS configuration changes, follow these steps:
Procedure
Step 1
switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# radius commit
Commits the RADIUS configuration changes to the running configuration.
Committing the TACACS+ Distribution
To commit TACACS+ configuration changes, follow these steps:
Procedure
Step 1
switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# tacacs+ commit
Commits the TACACS+ configuration changes to the running configuration.
Discarding the RADIUS Distribution Session
Discarding the distribution of a session in progress causes the configuration in the temporary buffer to be
dropped. The distribution is not applied.
To discard the RADIUS session in-progress distribution, follow these steps:
Cisco MDS 9000 Series Security Configuration Guide, Release 8.x
Committing the RADIUS Distribution
85