Craftsman 580.752060 Operator's Manual page 12

Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (152 cm) of clearance on all sides of
pressure washer including overhead.
• Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
How to Stop Your Pressure Washer
1. Release spray gun trigger and let engine idle for two
minutes.
2. Move engine switch to "Off" position.
Backfire, fire or engine damage could occur.
• DO NOT stop engine by moving choke rod to "Choke" position.
3. ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
4. Engage trigger lock on spray gun when not in use.
WARNING
WARNING
WARNING
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown below.
Low Pressure
High Pressure
40° White,
1750 PSI,
2.3 GPM
Follow these instructions to change spray tips:
1. Engage trigger lock on spray gun.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange spray tips without locking the trigger lock on
the trigger.
• DO NOT twist spray tips while spraying.
2. Pull back collar on quick–connect and pull current spray
tip off. Store spray tips in holder provided on the nozzle
extension.
12
Black
Use to apply
chemical
15° Yellow, 0 ° Red,
2200 PSI, 2500 PSI,
2.2 GPM 2.0 GPM
WARNING