Download Print this page

Lacrosse C86234 Quick Setup Manual page 2

Professional weather station

Advertisement

NOTE: When in 12h mode, there is only a 'PM' display, which appears under the word TIME. During the 'AM' hours this area will be blank.
 MINUTES: The Minutes will flash. Press and release the UP ARROW or DOWN ARROW button until the correct Minutes are displayed.
Press and release the SET button to confirm and continue.
 12/24-HOUR TIME: A 12h or 24h will flash. To change between 12h and 24h, press and release the UP ARROW or DOWN ARROW
button. Press and release the SET button to confirm and continue.
NOTE: When in 24-hour time the date will display Day first, then Month.
 YEAR: The Year will flash. Press and release the UP ARROW or DOWN ARROW button to set the correct Year. Press and release the
SET button to confirm and continue.
 MONTH: The Month will flash. Press and release the UP ARROW or DOWN ARROW button to set correct Month. Press and release the
SET button to confirm and continue.
 DATE: The Date will flash. Press and release the UP ARROW or DOWN ARROW button to set the correct Date. Press and release the
SET button to confirm and continue.
 FAHRENHEIT/CELSIUS: Degrees Fahrenheit or Celsius will flash in the Wind chill, Indoor and Outdoor temperature areas. Press and
release the UP ARROW or DOWN ARROW button to select between Fahrenheit and Celsius. Press and release the SET button to
confirm and continue.
 WIND SPEED UNIT: Wind Speed units will flash. Press and release the UP ARROW or DOWN ARROW button to select from mph, m/s,
knots, Beaufort, or km/h. Press and release the SET button to confirm and continue.
 RAIN UNIT: Rainfall Inches or Millimeters will flash. Press and release the UP ARROW or DOWN ARROW button to select in or mm.
Press and release the SET button to confirm and continue.
 PRESSURE UNIT: The Air Pressure units (inHg or hPa) will flash. Press the UP ARROW or DOWN ARROW button to select inHg or hPa.
The Default setting is inHg. Press and release the SET button to confirm and continue.
 RELATIVE PRESSURE SETTING: The Relative Air Pressure will flash. Press the UP ARROW or DOWN ARROW button to adjust the
Relative Air
Pressure.
Press and release the SET button to confirm and continue.
NOTE: Refer to your local weather station for an appropriate setting. It is important that this setting be adjusted for local conditions to
ensure forecast accuracy.
 FORECAST SENSITIVITY: The Forecast Sensitivity will flash. The default setting of .09 works well in most areas of the country, however
in areas with relatively constant pressure this should be set to .06, (within 30 miles of the coast) and in areas with significant pressure
changes this should be set to 0.12 (within 30 miles of the desert). Press the UP ARROW or DOWN ARROW key to adjust. Press and
release the SET button to confirm and continue.
 STORM ALARM SENSITIVITY: The Storm Alarm Sensitivity will flash. The default setting of .15 works well in most areas, however you
may need to adjust this level up or down depending on your local conditions. Use the UP ARROW or DOWN ARROW button to adjust.
Press and release the SET button to confirm and continue.
 STORM ALARM: AON or AOFF will flash. This will turn the Storm Alarm ON or OFF. Use the UP ARROW or DOWN ARROW button to
toggle the Storm Alarm ON (AON) and OFF (AOFF). Press and release the SET button to confirm and continue.
 WIND DIRECTION DISPLAY: The Dash in the Wind Compass will flash. Use the UP ARROW or DOWN ARROW button to select the
Wind Direction to be shown in degrees (dash) or letters NNW. Press and release the SET button to confirm and continue.
 FACTORY RESET: Res off will be displayed. Use the UP ARROW or DOWN ARROW button to select on only if you wish to Factory
Reset the Weather Center. If you do not wish to restart the weather center, be sure the Res off is showing and press and release the SET
button to complete the program menu.
NOTE: To Factory Reset the weather center, select Res on and press the SET button to confirm. The station will begin to count down
numbers in the date area. When it is complete it will say Done. Then remove the batteries and follow the Restart up procedure.
Press and release SET button to toggle between the display of Mode 1 or Mode 2:
MODE 1:
Wind Speed
Outdoor Temperature
24 hr. Pressure History Graph
Other buttons provide multiple functions:
UP ARROW:
LCD Display:
Display Modes:
MODE 2:
Wind Gust
Dew Point Temperature
72 hr. Pressure History Graph
2

Advertisement

loading