Raymarine C Series Quick Reference Manual page 3

Safety notices
Warning: Ensure safe navigation
This product (including the electronic charts) is
intended for use only as an aid to navigation. It is
designed to facilitate the use of official government
charts, NOT REPLACE THEM. Only official
government charts and notices to mariners contain all
the current information needed for safe navigation,
and the captain is responsible for their prudent use. It
is the user's responsibility to use official government
charts, notices to mariners, caution and proper
navigational skill when operating this or any other
Raymarine product.
Powering the display on
1. Press and hold the POWER button until the Raymarine logo
appears.
2. Press OK to acknowledge the warning window.
Powering the Display Off
1. Press and hold the POWER button until the countdown reaches
zero.
Note: If the POWER button is released before the countdown
reaches zero, the power off is cancelled.
Adjusting the backlight
1. Press the POWER button.
The backlight level meter is displayed.
2. Using the rotary contol, adjust the backlight to the appropriate
level.
Simulator mode
The Simulator mode enables you to practice operating your display
without data from a GPS antenna, radar scanner, fishfinder or AIS
receiver.
The Simulator mode is switched on/off in the System Setup Menu.
Once enabled, you can use the Simulator:
• Before installation: Connect the display to a 12V DC power
supply, fused at 1 amp by attaching the red core from the power
lead to positive (+) and the black core to negative (-).
• After installation: Whilst in a marina or at anchor.
Note: Incoming AIS safety messages cannot be displayed while
the display is in Simulator mode.
Note: Any system settings made whilst in Simulator mode are not
transmitted via SeaTalk to other equipment.
Enabling the simulator mode
1. Press Menu.
2. Select the System Setup menu.
3. Select the Simulator item, and change its value to On.
3