Dryer Switch-Off Status; Memory; Anti-Crease; Buzzer Is Active - Miele TWH620WP Operating Instructions Manual

Heat pump dryer
Table of Contents

Advertisement

Programmable functions
 Dryer switch-off status
To save energy the dryer will switch off
automatically after 15 minutes. You
can extend or reduce this time.
The dryer will switch off automatically
after 15, 20 or 30 minutes,
– if no further selection is made after
switching the dryer on,
– following the end of the anti-crease
phase,
– after a programme without an anti-
crease phase has finished.
However, there is no switch-off in the
event of a fault.
Options
 = after 15 minutes (default set-
ting)
 = after 20 minutes
 = after 30 minutes
 Memory
You can set the following: The elec-
tronic module will save the drying level
and any options selected for the cur-
rent drying programme. It will also
save the duration of the Warm air pro-
gramme. When the programme is se-
lected again, these saved settings will
appear in the display.
Options
 = Off (factory setting)
 = On
Exception:
The Cottons  programme will re-
main unchanged.
78
 Anti-crease
The drum will continue to rotate in a
special anti-crease rhythm for a max-
imum of 2 hours after the end of the
drying process. This helps prevent
creasing if laundry is not going to be
removed immediately. You can reduce
the duration of the anti-crease phase.
Options
 = no Anti-crease
 = 1 hour
 = 2 hours (default setting)
 Buzzer is active
The buzzer sounds to let you know the
programme has finished. It can be
switched on or off.
The continuous tone which sounds
when there are error messages is inde-
pendent of the buzzer.
Options
 = Off
 = On (factory setting)

Advertisement

Table of Contents
loading

Table of Contents