Dryer Switch-Off Status; Memory; Anti-Crease - Miele TDB130WP Eco Operating Instructions Manual

Heat pump dryer
Table of Contents

Advertisement

Programmable functions
 Dryer switch-off status
To save energy the dryer will switch off
automatically after 15 minutes. You
can extend or reduce this time.
The dryer will switch off automatically
after 15, 20 or 30 minutes,
– if no further selection is made after
switching the dryer on,
– following the end of the anti-crease
phase,
– after a programme without an anti-
crease phase has finished.
However, there is no switch-off in the
event of a fault.
Options
 = after 15 minutes (default set-
ting)
 = after 20 minutes
 = after 30 minutes
 Memory
Settings you can make: the electronics
can save a selected programme with a
drying level or specific options in its
memory. The duration of the Warm air
programme is also saved. These set-
tings will then appear the next time the
programme is selected.
Options
 = Off (factory default)
 = On
Exception:
The Cottons  programme will re-
main unchanged.
72
 Anti-crease
The drum will continue to rotate in a
special anti-crease rhythm for a max-
imum of 2 hours after the end of the
drying process. This helps prevent
creasing if laundry is not going to be
removed immediately. You can reduce
the duration of the anti-crease phase.
Options
 = no Anti-crease
 = 1 hour
 = 2 hours (default setting)

Advertisement

Table of Contents
loading

Table of Contents