Fault Codes - Fisher & Paykel DE7060M Installation Manual

When a continuous series of beeps is sounded, all the lights turn off on the control
panel and a number appears on the display, a fault has occurred. The dryer will
automatically enter this mode if a fault occurs. The fault code will be displayed as
followed by a number on the digital display. To stop the beeps, press any button then
perform the following steps:
Turn your machine off at the power socket.
1
Wait one minute and turn it back on.
2
Check your machine is installed correctly (refer to 'Installation instructions' section).
3
Remove your load from the dryer and retry.
4
Perform a 'Time Dry' cycle, eg 'Time Dry' for 30 minutes.
5
If the fault re-occurs repeat steps
6
If the machine still will not work call a Fisher & Paykel trained and supported service
7
technician to arrange service (refer to the 'Customer Care' section). Record the fault
code number displayed and the serial number of your dryer (located on the rear of the
machine, or on the inside of the door below the glass) before calling. The fault code will
indicate to the service technician what the problem could potentially be.
If a fault code is being displayed, you can still turn your dryer off by pressing 'POWER'
30

FAULT CODES

and .
1 2
.