Tensile Strength Unit; Factory Defaults; System Information; Unlock Options - BAQ alphaDUR mini Manual

SYSTEM SETTINGS

10.4.6 Tensile strength unit

Under the menu item System / Configuration / Tensile strength unit it can be
selected if the unit of tensile strength should be displayed as Mpa (Megapascal)
or N/mm2 (Newton per square millimetre).

10.5 Factory defaults

With the aid of the menu item System / Factory defaults, the current
measuring parameters and the date format can be reset to the default values.

10.6 System information

Select System / Info from the menu to display the system information. The
version numbers of software, kernel and system will be shown. If a probe is
connected, the serial number of the probe, the version of probe software and
the number of measurements done with this particular probe will be displayed
additionally.

10.7 Unlock options

Under the menu item System / Unlock options can the additional purchased
options be unlocked. The license is delivered on an USB flash drive. After
conncecting the flash drive to the alphaDUR mini, the option can be selected
and unlocked.

11 Maintenance and inspection

Periodically checks of the device should be executed with standard hardness
test blocks. The thickness of the test block is very important, due to the
measuring method. It should be no less than 16 mm. Test blocks of lesser
thickness (e.g. 6mm) aren't suitable. DKD-certified test blocks of 16 mm
thickness are available at the manufacturer of the device.
Depending on the frequency of use, a check / maintenance of the probes
should be performed at intervals of 1 to 2 years.
30