Leister BITUMAT B2 User Manual page 18

Operating preparation
• To achieve an even weld, there must be no bitumen deposits on the drive roller (13).
• In the case of soiling, the following measures can be taken:
– Release screws for scraper (26). Reduce the distance between the scraper (25) and the drive roller (13).
Tighten the screws for scraper (26).
– Release the fastening screw (14), remove and clean the drive roller (13). Mount the drive roller (13). Tigh-
ten the fastening screw (14).
– Release the fastening screw (14) and remove the drive roller (13). Release the Screw-on additional
weight (23), remove the replacement drive roller (22) from the holder (27). Mount the replacement
drive roller (22) with the fastening screw (14). Place the soiled drive roller (13) into the holder (27)
and secure with the Screw-on additional weight (23).
• Connect tool to rated voltage.
230
FI
400
18
Rated voltage stated on the device must correspond to line/mains voltage.
13
25
26
26
23
22
13
27
14