Table of Contents
Advertisement
General Information
demonstrate that the GDL 90 is compatible with existing FCC regulations in 47 CFR2 and 47
CFR87.
Use of UAT for government programs, such as Capstone Phase 1 and Phase 2 in Alaska, has
been fully coordinated with NTIA, and is authorized. In December of 2000, the RTCA created
Working Group 5 of Special Committee 186, to develop and approve the Minimum Operational
Performance Standards for the UAT data link. The effort was completed in June 2002. As part
of this effort, the NTIA has granted Stage 4 spectrum certification for use of the UAT data link
using a radio frequency of 978 MHz.
1.4.4
GDL 90 STC A
Refer to the GDL 90 Product CD 140-0063-xx for data regarding GDL 90 STC authorization.
1.5 U
NPACKING THE
Carefully unpack the equipment. Visually inspect the package contents for any evidence of shipping
damage. Retain all shipping containers and packaging material in case reshipment is necessary.
1.6 P
C
ACKAGE
As shipped from the Garmin AT factory, the GDL 90 package includes most necessary items for
installation other than supplies normally available at the installation shop, such as wire and cable ties,
circuit breakers, and required input and output equipment. The items included in the package are listed in
Table 1-2 and Table 1-3. In addition, Table 1-4 lists optional parts that may be needed for non-standard
installations.
Part #
424-6081-1xx
430-6081-1xx-xxx
140-0063-xx
590-1104
590-0051
Part #
162-0043
265-0007
240-0008
162-1574
162-1575
162-1577
162-2080
202-0002
224-0404
245-0027
310-0461-00
310-0462-00
430-6200-000
660-0014
1-10
UTHORIZATION
E
QUIPMENT
ONTENTS
Table 1-2. Package Contents
Qty
1
GDL 90 Installation Kit (see Table 1-3 for detail)
1
GDL 90 UAT Data Link Sensor
1
GDL 90 Product CD
1
A33 GPS Antenna
2
UAT Blade Antenna, passive, TNC
Table 1-3. Installation Kit Contents (PN 424-6081-100)
Qty
3
Connector, coax, RA, PNL MNT
3
Retainer Ring, ext,7/16 shaft
3
Washer, 0.446 ID 0.56 OD
1
Receptacle DSUB 9-pin
1
Receptacle DSUB 15-pin
1
Receptacle DSUB 37-pin
3
Connector, coax, RA, plug clamp, TNC
8
Cable tie
4
Screw, 4-40 x 1/4 SS flat head Phillips 82 deg.
25
Crimp contact, DSUB, 20 to 24 AWG wire
1
Cover Mounting Tray GDL 90
1
Mounting Tray GDL 90
1
Aircraft Personality Module (APM)
50
Cable, coax RG400 dbl shld 50-ohm (feet)
560-1049-00 Rev B
Description
Description
GDL 90 Installation Manual
Advertisement
Table of Contents
