Table of Contents
Advertisement
5.5 Installing the RF Jumper
Prerequisite
The ZXSDR RSUC RF cabinet and other modules have already been installed.
Context
The RF jumpers for the three ZXSDR RSUC go through the waterproof module on the
right.
Remove the front baffle of the base before installing the RF jumpers and reseat the front
baffle after all jumpers are completely installed.
Steps
1. Connect the RF jumpers to ANT1 and ANT2 interfaces of RSU from left to right.
2. Wear the waterproof rubber plug after every two RF jumpers are installed.
3. Insert the horizontal and longitudinal slide blocks and use the hexagon ring wrench to
fasten them.
Clamp the waterproof rubber plug tightly and make sure that the unused cabling
aperture wears the plug.
4. Repeat the preceding steps to install other RSU-related jumpers.
– End of Steps –
Result
Figure 5-16
SJ-20101019140047-002|2012-03-15 (R1.1)
Caution!
shows the completion of installing the RF jumpers.
Chapter 5 Hardware Installation
5-15
ZTE Proprietary and Confidential
Advertisement
Table of Contents
