Figure 5-11 Waterproof Module Through Which Optical Fibers Pass - Zte ZXSDR RSUC User Manual

Affix temporary labels to both ends of the new optical fiber to set up a mapping. If
more than one optical fiber needs to be installed, use different labels to differentiate
optical fibers.
2. Route optical fibers.
a. Optical fibers go out from the side waterproof module of the baseband module and
go through the routing apertures on the base.
b. Then, optical fibers go through the routing apertures on the base of the RF cabinet,
traverse the waterproof modules, and connect to the six optical interfaces for RF
modules.
Figure 5-11

Figure 5-11 Waterproof Module through Which Optical Fibers Pass

3. Insert optical fiber connectors.
Insert optical fiber connectors according to the mapping on temporary labels.
Caution!
Insert optical fiber connectors tightly.
4. Bundle optical fibers.
Bundle and secure optical fibers along the routing troughs, which complies with
relevant regulations.
5. Affix an engineering label to an optical fiber.
Remove the temporary label for the optical fiber and affix an engineering label.
SJ-20101019140047-002|2012-03-15 (R1.1)
shows how optical fibers traverse the waterproof modules.
5-11
Chapter 5 Hardware Installation
ZTE Proprietary and Confidential