Direction Indicators - Bosch LR 6 Operating Instructions Manual

When no button is pressed on the tool for approx. 20 minutes
and when no laser beam reaches the reception area 9 for 20
minutes, the tool automatically switches off in order to save
battery power.
Selecting the Setting of the Center Indicator
With button 1, you can specify with which accuracy the position
of the laser beam is indicated on the reception area:
– "Fine" adjustment (the centre-indication LED 7 flashes),
– "Coarse" adjustment (the LED direction indicators 8 and 6
flash).
Whenever switching on the tool, the accuracy level "Fine" is set.
The position of the laser beam on the reception area 9 is indi-
cated:
– via the LEDs "move downward" 8, "move upward" 6 or the
center-indication LED 7 on the front and back of the tool,
– optionally via the audio signal (see "Audio Signal for Indication
of the Laser Beam").
Tool too low: When the laser beam runs through the top half of
the reception area 9, the corresponding direction LED 6 lights
up. When the audio signal is switched on, a high frequency signal
sounds. Move the tool upward in the direction of the arrow.
Tool too high: When the laser beam runs through the bottom half
of the reception area 9, the corresponding direction LED 8 lights
up. When the audio signal is switched on, a low frequency signal
sounds. Move the tool downward in the direction of the arrow.
Tool in center position: When the laser beam runs through the
reception area 9 at the center mark 12, the corresponding center-
indication LED 7 lights up. When the audio signal is switched on,
a continuous signal sounds.

Direction Indicators

-10-