WHAT YOU WILL NEED
Here's everything you will need to upgrade your Quaverato with the MIDI mod kit. In this assembly
manual, we are assuming:
1. you have a Quaverato Harmonic Tremolo pedal, as a kit underway, or already assembled and
in-service;
2. you know how to solder and how to use tools safely; but
3. you have no other particular experience with electronics.
SOFTWARE
Quaveratos shipped after November 16, 2018 come loaded with the latest MIDI-enabled software
(version 2.3.6 or higher). If you are modding an older unit, you will need to update the software.
Updates are easily obtained with the free
hardware called a
USB-Tiny
TOOLS
1.
Soldering Iron (not a soldering gun, or a "cold heat" iron), good quality, 15-50 watt, with a good medium
or small sized tip, conical or "screwdriver" shape. One with a temperature control and a stand is best. Also,
make sure you have a way to clean the tip: a wet sponge or a dry solder cleaning pad.
2.
#2 Philips Screw Driver
3.
Flush cutters or small diagonal cutters
4.
Needle-nose pliers
5.
Clamp or vise
6.
Solder sucker or solder braid – optional, but very handy if you have to remove / repair any components!
7.
A center punch, awl, or nail-like sharp object
8.
Drill press or other small power drill capable of drilling through the chassis
9.
Drill bits: 1/8", 3/16, and 1/4" (3 mm, 4 or 5 mm, 6 mm)
10.
Deburring tool or large drill bit around 7/16"
11.
4" length of 2x4 block of wood or similar, to drill into
12.
Scissors
SUPPLIES
1.
Solder, 60/40 rosin core, the smaller diameter the better (we prefer .032" diameter). Make sure it's good
quality; we prefer Kester brand, but most brands will work fine.
2.
Masking or painters tape
ZDL Updater
Programmer. See "UPDATING THE SOFTWARE" on page 17.
3
app for PC. You will also need a little piece of