Advertisement
2. Cut out the paper drilling template by cutting around the solid line (5). Align the template to the
front of the bottom half of the chassis (6). As you hold the template in place, hold it up to the
light to align the holes in the chassis to the hole markings on the paper. The edge of the template
should line up with the edge of the chassis. While making sure the template doesn't move from
that position, use a few pieces of tape to hold it in place (7,8).
5
7
3. With a center punch or a sharp, nail-like object (such as a nail), punch a divot in the chassis at
the location indicated on the template (9). If you use a hammer and nail, do not stand the chassis
up on top of the table as we did here. You might badly bend the chassis. Instead, hang the
chassis over the edge of your work bench, so that the chassis face is supported directly by the
table. Once you have made your mark, remove the template (10).
9
6
8
10
14
Advertisement
