Advertisement
4. Slide the two parts of the chassis together by lining up the 1/4" jacks to the holes on the bottom
chassis (7). While the chassis is still open, plug the other end of the 4-pin ribbon cable into the
header on the Quaverato's PCB (8). It is important to make sure the wire is not twisted. Close the
chassis. Make sure the power jack is properly lined up with its square hole on the chassis and
that it didn't end up behind the hole (9).
7
9
5. Replace the 4 screws and two nuts you removed earlier (10,11).
10
That's it!
Your Quaverato is ready to be controlled by your favorite MIDI controller or sequencer or DAW. Please
see the
Quaverato MIDI User Manual
8
11
for the details of how MIDI works on the Quaverato.
19
Advertisement
