Listening To The Radio - Sharp CD-BH20 Operation Manual

Listening to the radio

■ Tuning
1
Press the (ON/STANDBY) button to turn the power
on.
2
Press the TUNER (BAND) button (remote control)
or INPUT button (main unit) repeatedly to select FM
Stereo, FM Mono or AM.
3
● Manual tuning:
Press the TUNING (
control) repeatedly to tune in to the desired station.
● Auto tuning:
Press and hold the TUNING (
Scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING
( or ) button again.
To receive an FM stereo transmission:
● Press the TUNER (BAND) button to select stereo
mode. "ST" indicator will be displayed. "
appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER (BAND)
button to extinguish the "ST" indicator. The reception
changes to monaural, and the sound becomes clearer.
or ) button (remote
or ) button.
" and " " will
■ Memorizing a station
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in memory. If the "MEM" and preset num-
ber indicators disappear before the station is memo-
rized, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorized for that pre-
set channel number will be erased.
Note:
The backup function protects the memorized stations for a
few hours should there be a power failure or the AC power
cord become disconnected.
■ To recall a memorized station
Press the PRESET (
station.
■ To scan the preset stations
1
Press and hold the PRESET (
preset number flashes. The programmed stations will
be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
desired station is located.
■ To erase entire preset memory
1
Press the (ON/STANDBY) button to turn the power on.
2
Press the INPUT button (main unit) repeatedly or
TUNER (BAND) button (remote control) to select
Tuner function.
3
In Tuner function, press and hold the CLEAR button
(remote control) until "Tuner Clear" appears.
E-14
or ) button to select the desired
or ) button until the
or ) button again when the