Table of Contents
Advertisement
In-Feed/Discharge Air Pressure
L-300 Outline and Details
Flowmeter Details
hex head bolt M12-
1.75 x 25 (12)
lockwasher ø12 (12)
latch (TYP)
enclosure with doors
and hardware
Flowmeter details are continued on the next page.
7ML19985EQ01
•
To common
dust collector
•
•
Flowguide with gasket
Milltronics L-300 – INSTRUCTION MANUAL
If a material in-feed/discharge differential air
pressure is anticipated and rotary airlock
feeders are not used, vent the in-feed and
discharge chutes to a common dust collector.
Install a tuning gate in each vent to balance the
air pressure.
If a dust collector is not used, install an air
bypass chute between the flowmeter in-feed
and discharge chutes.
connectors
conduit (2 m)
load cell leads
load cell labels (2)
housing (cabinet)
hinge (TYP)
Page 11
Advertisement
Table of Contents
