Displaying And Debugging Rip - H3C S9500 Series Operation Manual

Operation Manual – RIP
H3C S9500 Series Routing Switches
Perform the following configuration in Interface view to set/disable RIP-2 packet
authentication:
Configure RIP-2 simple authentication
key
Perform usual MD5 authentication on
RIP-2 packets
Perform nonstandard-compatible MD5
authentication on RIP-2 packets
Disable RIP-2 packet authentication
Before configuring MD5 authentication, you must configure the MD5 type. The usual
packet format follows RFC1723 and the nonstandard follows RFC2082.

1.3 Displaying and Debugging RIP

Display the current RIP running state
and configuration information.
Enable the RIP packet debugging
information
Disable the RIP packet debugging
information
Enable the debugging of RIP
receiving packets
Disable the debugging of RIP
receiving packets
Enable the debugging of RIP sending
packet
Disable the debugging of RIP sending
packet
Reset the system configuration
parameters of RIP
1.4 RIP Configuration Example
I. Network requirements
As shown in
117.102.0.0 through the Ethernet port. The Ethernet ports of the S9500 series routing
switches A and Switch B are respectively connected to the network 155.10.1.0 and
To do...
To do...
Figure 1-1, the S9500 series routing switch C connects to the subnet
1-12
Chapter 1 RIP Configuration
Use the command...
rip authentication-mode simple
password-string
rip authentication-mode md5 usual
key-string
rip authentication-mode md5
nonstandard key-string key-id
undo rip authentication-mode
Use the command...
display rip
debugging rip packet
undo debugging rip
packet
debugging rip receive
undo debugging rip
receive
debugging rip send
undo debugging rip
send
reset
Remarks
Available in any
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in RIP
view