Configuration; Displaying And Debugging Common Multicast Configuration - H3C S9500 Series Operation Manual

Operation Manual – Multicast Protocol
H3C S9500 Series Routing Switches

4.4.2 Configuration

Table 4-8 Configuring Broadcast/Multicast Suppression
Operation
Enter system view
Enter Ethernet port
view
Configure
suppression
Ethernet port
Configure broadcast
suppression
Ethernet port
Caution:
You cannot enable both broadcast suppression and multicast suppression
simultaneously on the same card. Namely, once you have enabled broadcast
suppression on some ports of a card, you cannot enable multicast suppression on
the other ports of the card, and vice versa.
If multicast suppression is enabled, broadcast packets are also suppressed at the
same time, while broadcast suppression does not work on multicast suppression.
No distinction is made between known multicast and unknown multicast for
multicast suppression.
4.5 Displaying and Debugging Common Multicast
Configuration
After the above configuration, execute display command in any view to display the
running of the multicast configuration, and to verify the effect of the configuration.
Execute debugging command in user view for the debugging of multicast.
Command
system-view
interface interface-type
interface-number
multicast multicast-suppression
ration { ratio
bandwidth }
broadcast-suppression
ration { ratio
bandwidth }
4-6
Chapter 4 Common Multicast Configuration
-
Required
interface-type
Ethernet
Optional
| bandwidth
By
suppression ratio is 100%
Optional
| bandwidth
By
suppression ratio is 50%
Description
must
default, the multicast
default, the broadcast
be