Displaying And Debugging Mstp - H3C S9500 Series Operation Manual

Operation Manual – MSTP
H3C S9500 Series Routing Switches
Table 1-36 Configure fast transition in system view
Enter system view
Enable fast transition
Configuring fast transition in Ethernet port view
Table 1-37 Configure fast transition in Ethernet port view
Enter system view
Enter Ethernet port view
Enable fast transition
Note:
You can configure fast transition only on a root port or an alternate port.

1.3 Displaying and Debugging MSTP

After the above configuration, execute the display command in any view to display the
running of the MSTP configuration, and to verify the effect of the configuration. Execute
the reset stp [ interface interface-list ] command in user view to clear the statistics of
MSTP module. Execute the debugging command in user view to debug the MSTP
module
Table 1-38 Display and debug MSTP
Display the MSTP information about the
current switch
Display the configuration information
about the current port and the switch
Display the current configurations of the
specified service board
To do...
system-view
stp interface interface-type
interface-number
no-agreement-check
To do...
system-view
interface interface-type
interface-number
stp no-agreement-check
To do...
Use the command...
Use the command...
Use the command...
display stp
display stp [ instance instance-id ]
[ interface interface-list | slot slot-num ]
[ brief ]
display stp slot number [ brief ]
1-41
Chapter 1 MSTP Configuration
Remarks
—
Required
By default, port fast
transition is disabled.
Remarks
—
—
Required
By default, port fast
transition is disabled.