Speed Limiter; Power Save Mode; Fatigue Driving Alarm - Topten GT08 User Manual

GT08 GPS Vehicle Tracker
(For example: 111111SPD:120, if the car speed is over 120KM/H, it will
send out warning alert by SMS/platform).
111111SPD:0
111111SPD:
Remark: this function is just for reference, because there might be some
time delay or error in detecting the running car's real speed by GPS. Default
speed limitation is 120KM/H.

Speed Limiter

After user sets the speed limitation by command 111111SPD:X, if car is over
speed, the car will be slowed down gradually.
111111BUZ:3:X,
(X=1, activate siren; X=0: deactivate siren; default=1)
111111RLY:3:X,
(X=1, activate relay; X=0: deactivate relay; default=1)

Power Save Mode

SMS command: 111111PWR:X
Value of X
0 (default) Disable power save mode
1 Close GPRS connection
2 Close GPRS connection, GPS module
After setting 111111PWR:1(or 2), if there is no vibration & SOS alarm,
integration line is not triggered, and ACC is OFF, the tracker will go into power
save mode after 5 minutes.
Once there is vibration or SOS alarm, or integration line is triggered, or ACC
is ON, the tracker will wake up from the power save mode immediately.

Fatigue Driving Alarm

When this function is activated, if the engine is turned on for a certain time,
the siren will sound to warn the driver. The SMS command:
111111TIR:1:X,
to disable the over-speed alert. It is the default setting.
to check the setting of over-speed alert.
Actions
(with, at the end)
Page 8
User Manual
Power consumption
60mA
48mA
13mA