Huawei eSpace 6870 User Manual page 23

EchoLife ET685 IP Phone User Manual
Menu Configuration Description
Config Display the configuration submenus.
Press LEFT or select Back to return to the main menu.
These items are used for factory testing and not recommended for
Factory
Functions
users.
Press LEFT or select Back to return to the main menu.
Network Enable or disable the DHCP protocol. Set the IP address, subnet
mask, and gateway address by using the keypad if the static IP
mode is selected.
Reboot Reboot the device.
Exit Exit the menu.
[SIP]
Set the SIP server for each account, including account, SIP
proxy, Outbound proxy, SIP user ID, SIP Auth ID, SIP
password, SIP transport, and Audio CODECs.
[Upgrade]
Configure the firmware server and the file download server.
Select either TFTP or HTTP to upgrade the firmware or
configure the phone.
[Factory Reset]
Type the MAC address on back of the phone. Press the soft key
OK to restore the factory reset settings. Factory reset clears all
configurations and restores the phone to factory settings.
[Layer 2 QoS]
Configure the 802.1Q/VLAN tag and 802.1P priority.
[Audio Loopback]
Speak to the handset. If you hear your voice in the handset,
your audio works well. Press MENU to exit the mode.
[Diagnostic Mode]
All LEDs are on. Press any key on the keypad to display the
key name on the LCD. Pick up the handset or press MENU to
exit the diagnostic mode.
4 Configuring
17
the eSpace 6870